wsm ME8200 Workshop Manual page 261

ME8200, ME9000, WSM
(D) Disassembling Transmission Case
Hydraulic Cylinder Assembly
1. Remove the stay (1) and brake pipe (2).
2. Remove the delivery pipe 2 (3).
3. Disconnect the brake rod (5) and remove the parking brake lever
(4).
4. Remove the lift rods from lift arms.
5. Remove the hydraulic cylinder assembly mounting screws and
nuts.
6. Support the hydraulic cylinder assembly with nylon lift strap and
hoist, and then remove it.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the hydraulic cylinder assembly and transmission case after
eliminate the water, oil and stuck liquid gasket.
Hydraulic cylinder
Tightening torque assembly mounting screw
and nut
NOTE
• Reassemble the hydraulic cylinder assembly to the tractor,
be sure to adjust the position control feedback rod and draft
control rod.
(1) Stay
(2) Brake Pipe
(3) Delivery Pipe 2
Rear Axle L.H.
1. Remove the rear axle case mounting screws and nuts.
2. Support the rear axle assembly with nylon lift strap and hoist, and
then remove it.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the rear axle case and transmission case, after eliminate the
water, oil and stuck liquid gasket.
Rear axle case mounting
Tightening torque
screw and nut
Brake Cam Plate
1. Remove the return spring (1).
2. Remove the brake cam plate (2).
(When reassembling)
• Apply grease to the brake ball seats.
excessively.)
(1) Return Spring
3-S41
TRANSMISSION
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 lbf·ft
(4) Parking Brake Lever
(5) Brake Rod
W1066039
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 lbf·ft
W1066800
(Do not grease
(2) Brake Cam Plate
W1067333
KiSC issued 03, 2007 A