Disassembling And Assembling - wsm ME8200 Workshop Manual

ME8200, ME9000, WSM

(2) Disassembling and Assembling

(A) Cab Windshield
2) Rear Wiper Switch
1. Check the continuity through the switch with an ohmmeter.
2. If continuity specified below is not indicated, the switch is faulty.
Terminal
Position
WASH I
OFF
Front wiper
switch
ON
WASH II
(1) Rear Wiper Switch
Rear Wiper Motor
1. Raise up the rear wiper arm (1).
2. Turn the main switch ON.
3. Push the rear wiper switch to ON position.
4. Count the number of wiper arm rocking per minutes.
5. If the number differs from the factory specifications, replace the
wiper motor (3) assembly.
No. of wiper arm swing
Factory spec.
frequency at no load
(1) Wiper Arm
(2) Wiper Blade
Preparation
1. Prepare the followings.
- Cutter knife 1 piece
- Scraper 1 piece
- Gun for coating 1 piece
- Sika Tack-Ultrafast or equivalent
- Sika-cleaner No. 1
- Gummed tape
NOTE
• Sika Tack-Ultrafast and cleaner No. 1 are made by Sika
Corporation.
• These materials can't be provided by Kubota Corporation.
• Therefore, please find the local made equivalent materials in
your country and use them when you need.
10-S48
-S +1 B W
(2) Rear Wiper Switch Connector
(Switch Side)
36 to 50 times / min.
(3) Wiper Motor
CABIN
–
W1034723
W1035084
W1035271
KiSC issued 03, 2007 A