wsm ME8200 Workshop Manual page 236

ME8200, ME9000, WSM
(C) Separating Clutch Housing Case (CABIN Type)
Lift Rods and Lower Links
1. Remove the lift rods (1).
2. Remove the lower links (2) with stabilizer.
3. Remove the drawbar.
4. Remove the PTO shaft cover (3).
5. Remove the rear wheels.
(When reassembling)
Tightening torque Rear wheel mounting nut
(1) Lift Rod
(2) Lower Link
Dismount Cabin
1. See "Separating Cabin from Tractor Body" section (page 10-
S24).
Propeller Shaft
1. Slide the propeller shaft covers (3), (5) after removing the screw
(6).
2. Tap out the spring pins (2), (4) and then slide the couplings (1),
(8) to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
• Tap in the spring pins (2), (4) as shown in figure.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
3-S16
TRANSMISSION
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(3) PTO Shaft Cover
W1145746
W1145921
(5) Propeller Shaft Cover
(6) Screw
(7) Propeller Shaft
(8) Coupling
W1145990
KiSC issued 03, 2007 A