wsm ME8200 Workshop Manual page 199

ME8200, ME9000, WSM
Propeller Shaft
1. Slide the propeller shaft covers (3), (5) after removing the screw
(6).
2. Tap out the spring pins (2), (4) and then slide the couplings (1),
(8) to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
• Tap in the spring pins (2), (4) as shown in figure.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Spring Pin
Fuel Tank Connection Hose
1. Remove the cover (2).
2. Remove the connection hose (1).
(When reassembling)
Tightening torque Cover mounting screw
(1) Connection Hose
Lift Rods and Lower Links
1. Remove the lift rods (1).
2. Remove the lower links (2) with stabilizer.
(1) Lift Rod
2-S17
CLUTCH
(5) Propeller Shaft Cover
(6) Screw
(7) Propeller Shaft
(8) Coupling
W1019282
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 lbf·ft
(2) Cover
W1019664
(2) Lower Link
W1019863
KiSC issued 03, 2007 A