wsm ME8200 Workshop Manual page 200

ME8200, ME9000, WSM
Speed Change Base
1. Remove the lever grip (1).
2. Remove the cover 1 (2) and cover 2 (3).
3. Disconnect the select wire (7) from the base (8).
4. Remove the main speed change rod 1 (6).
5. Disconnect the control wire (4), (5) for auxiliary control valve.
6. Remove the speed change base (8).
(When reassembling)
• Install the control wire (5) of first valve (lower side) into the rear
side slot.
• Execute the following "Adjusting of Select Wire" and
"Adjusting of Control Wire for Auxiliary Control Valve".
Length of main speed
Factory spec.
change rod 1 (L)
(1) Lever Grip
(2) Cover 1
(3) Cover 2
(4) Control Wire
(Adjusting of Select Wire)
1. Screw in the wire (2) fully to the rod end (1).
2. Fix the wire (2) so that the threaded portion A and B become the
same.
3. Disconnect the wire (2) from the select lever (3) once.
4. Shift the main speed change lever (7) to the 1st-2nd side until the
lever touches stopper (6), then shift the select lever (3) to the 1st-
2nd side.
5. Check that the hole (5) of the wire end is corresponding to the
projection on the select lever (3).
6. If not, adjust by the nut (4).
7. Reconnect the select wire (2) to the select lever (3).
(1) Rod End
(2) Select Wire
(3) Select Lever
(4) Nut
2-S18
CLUTCH
457 mm
17.99 in.
(5) Control Wire
(6) Main Speed Change Rod 1
(7) Select Wire
(8) Speed Change Base
W1020004
(5) Hole
(6) Stopper
(7) Main Speed Change Lever
W1020565
KiSC issued 03, 2007 A