wsm ME8200 Workshop Manual page 208

ME8200, ME9000, WSM
Separating Transmission Case
1. Remove the transmission case mounting screws and nut, and
separate the transmission case from the clutch housing.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the transmission case and clutch housing, transmission upper
cover and transmission case.
Transmission case
Tightening
and clutch housing
torque
mounting screws, nut
PTO Clutch Valve
1. Disconnect the PTO clutch valve cable (1).
2. Remove the PTO clutch valve (2).
(When reassembling)
• Apply transmission fluid to O-ring.
• Remove the two hydraulic pipes from the PTO clutch holder.
• Insert both the hydraulic pipes into the PTO clutch valve holes
down to the bottom.
• Now while aligning the hydraulic pipe ends with the PTO clutch
holder holes, assemble the PTO clutch valve (2) to the
transmission case.
PTO clutch valve mounting
Tightening torque
screw
(1) PTO Clutch Valve Cable
PTO Clutch and Holder
1. Remove the PTO clutch holder mounting screws.
2. Remove the PTO clutch (4) with holder.
(When reassembling)
• Apply transmission fluid to O-ring.
• Take care not to damage the oil pipes (1).
PTO clutch holder
Tightening torque
mounting screw
IMPORTANT
• After assembling the PTO clutch assembly, be sure to check
the piston operation by air-blowing.
(1) Oil Pipe
(2) Holder
2-S26
CLUTCH
M12, 103.0 to 117.7 N·m
grade 9 10.5 to 12.0 kgf·m
nut 75.9 to 86.8 lbf·ft
M12, 77.5 to 90.2 N·m
grade 7 7.9 to 9.2 kgf·m
screws 57.1 to 66.5 lbf·ft
W1025540
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(2) PTO Clutch Valve
W1025755
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(3) Brake Plate
(4) PTO Clutch Pack
W1026012
KiSC issued 03, 2007 A