wsm ME8200 Workshop Manual page 60

ME8200, ME9000, WSM
NOTE
• The following special tools are not provided, so make them referring to the figure.
Nozzle Tester
Code No.: 07909-31361
Application: Use to check the fuel injection pressure and spray
pattern of nozzle.
Measuring: 0 to 50 MPa
range (0 to 500 kgf/cm
Plastigage
Code No.: 07909-30241
Application: Use to check the oil clearance between crankshaft and
bearing, etc.
Measuring: Green .... 0.025 to 0.076 mm (0.001 to 0.003 in.)
range Red ....... 0.051 to 0.152 mm (0.002 to 0.006 in.)
Blue ....... 0.102 to 0.229 mm (0.004 to 0.009 in.)
Red Check
Code No.: 07909-31371
Application: Use to check cracks on cylinder head, cylinder block,
etc.
Bushing Replacing Tool
Application: Use to press out and to press fit the bushing.
1. For small end bushing
A 196 mm (7.7165 in.)
B 37.5 mm (1.476 in.)
C 150 mm (5.9055 in.)
D 45.95 mm dia. (1.7697 in. dia.)
E 48.100 to 48.075 mm dia. (1.8937 to 1.8927 in. dia.)
F 20 mm (0.7874 in.)
6.3 μm (250 μin.)
a
6.3 μm (250 μin.)
b
G-41
G GENERAL
2
, 0 to 7000 psi)
KiSC issued 03, 2007 A
W10246530
W10247190
W10249090
W1025500