wsm ME8200 Workshop Manual page 540

ME8200, ME9000, WSM
Before Replacing Windshields (1)
[In case of using piano wire (When glass is cracked)]
1. Thread the piano wire from the inside of cabin. Tie its both ends
to a wooden blocks or the like. (See the left figure.)
2. Pull the piano wire inward/outward alternately to cut the adhered
part.
NOTE
• Do not let the piano wire make sliding contact with the edge
of glass plate forcibly.
[In case of using cutter knife (When glass is totally crushed
finely)]
1. Insert the knife (3) into the adhered part.
2. Keep the edge of knife blade square to the glass edge at the part
(a). Slide the knife blade along the glass surface and the edge.
Pull the part (b) in the direction parallel to the glass edge to cut
them off.
NOTE
• Find a wider gap between the glass and body.
• Take care of handling the cutter knife not to damage your
hand.
(1) Piano Wire
(2) Wood Peace
Before Replacing Windshields (2)
1. When the Sika Tack-Ultrafast or equivalent attached to the cabin
frame and the glass are reused, remove the bond clearly.
2. Clean the frame surface with Sika-cleaner No. 1.
NOTE
• Remove the bond completely.
10-S49
(3) Cutter Knife
(4) Pulling
W1035600
W1035852
KiSC issued 03, 2007 A
CABIN