wsm ME8200 Workshop Manual page 289

ME8200, ME9000, WSM
Clearance between Planetary Gear and Planetary Gear Shaft
1. Measure the planetary gear shaft O.D. (rubbing surface).
2. Measure planetary gear I.D. (rubbing surface).
3. Measure the O.D. of the two needles installed diagonally in the
needle bearing.
4. Calculate the clearance.
5. (Clearance = Planetary gear I.D. - {(2 x Needle O.D.) + Planetary
gear shaft O.D.}).
6. If the clearance exceeds the allowable limit, replace them.
Factory spec.
Clearance between
planetary gear and
planetary gear shaft
Allowable limit
Planetary gear shaft
Factory spec.
O.D.
Planetary gear I.D. Factory spec.
Factory spec.
Needle O.D.
4-S13
REAR AXLE
0.009 to 0.048 mm
0.00035 to 0.00189 in.
0.30 mm
0.0118 in.
31.989 to 32.000 mm
1.25941 to 1.25984 in.
39.000 to 39.025 mm
1.53543 to 1.53641 in.
3.494 to 3.500 mm
0.13756 to 0.13780 in.
W1022512
KiSC issued 03, 2007 A