wsm ME8200 Workshop Manual page 323

ME8200, ME9000, WSM
Front Wheel Case Cover
1. Remove the front wheel case cover from the front wheel case by
screwing M10 screws into hole A and B.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to the front
wheel case cover.
Front wheel case cover
Tightening torque
mounting screw
Front Wheel Case
1. Remove the internal snap ring (13).
2. Remove the cap (12) which is installed in the bottom of front
wheel case.
3. Remove the internal snap ring (11) and take out the adjusting
shims (10).
4. Tap out bevel gear to downward, and take out the bevel gear (8)
and bearing (9) as a unit.
(When reassembling)
• Apply grease to the front wheel case DX bushing (2).
• Apply grease to the oil seal.
• Install the oil seal (1) to the front wheel case so that its lips faces
the inward.
• Install the internal snap ring (11) as shown in the figure left side
so that align the gap of internal snap ring (11) and by-pass hole
(A).
• Apply gear oil to the cap.
(1) Oil Seal
(2) DX Bushing
(3) Thrust Ball Bearing
(4) Plug
(5) Front Wheel Case
(6) Plug
(7) Ball Bearing
(8) Bevel Gear
6-S10
FRONT AXLE
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 lbf·ft
W1071352
(9) Ball Bearing
(10) Shim
(11) Internal Snap Ring
(12) Cap
(13) Internal Snap Ring
A : By-pass Hole
W1071506
KiSC issued 03, 2007 A