Change the print delivery settings
Change the print delivery settings
Introduction
Usually the print delivery settings have been defined in the printer driver.
Overview of the print delivery settings
Setting
[Output location]
[Sort]
[Offset stacking]
[Advanced settings]
Procedure
1.
Touch [Jobs] -> [Waiting jobs], or select a [DocBox].
2.
Touch the job of which you want to change the settings.
NOTE
You can only change the settings of the active print job
[Stop] button
3.
Press [Properties].
4.
Touch the [Print delivery].
5.
Make the required changes.
6.
Press [OK].
7.
Press [OK].
196
Chapter 8 - Carry out print jobs
Description
Change the output location for the job. The list shows all the out-
put locations that are available for your system.
Make sure there is a match between the selected output location
and the job requirements. For example, when a job requires sta-
ples, you must select an output location that allows stapling.
Change the sorting method of the prints. You can select sort [By
page] or [By set].
[56] Sort by page
[57] Sort by set
Stack the prints with an offset.
This setting is only available when the [Offset stacking] setting of
the active [Workflow profile] is set to [Sets (as in job)].
Finishing equipment often requires that the printed sheets are de-
livered in a certain order. For finishers that are integrated in your
printing system, the required settings are adapted automatically.
However, sometimes it can be necessary to change a number of
settings manually, for example when you want to finish the prints
using offline finishers. If required, you can change the [Sheet or-
der], [Sheet orientation], [Print order] and [Rotation].
two times).
after you stopped the printer (press the