Removing The Punch Waste - Canon IMAGEPRESS C7011VPS SERIES Operation Manual

Removing the punch waste

Removing the punch waste
Introduction
This section describes how to remove the punch waste
IMPORTANT
Take care when handling the optional equipment that is attached to the machine. When an
optional unit's cover is opened to replace a staple cartridge, discard punch waste, or clear paper
or staple jams, prints may still be output if other optional units are operating normally, and are
not involved in the paper or staple jam removal procedure
NOTE
This procedure is necessary only if the optional Puncher Unit-BB1 is attached to the optional
Finisher-AJ1 or Saddle Finisher-AJ2.
Procedure
1.
Open the front cover of the finisher.
2. Pull out the punch waste tray.
3. Discard the punch waste into a receptacle.
152 Chapter 7 - Media handling