Canon IMAGEPRESS C7011VPS SERIES Operation Manual page 120

Load the media into the bulk media module (optional)
IMPORTANT
• Do not load paper into the paper tray that has been previously printed onto, as this may result
in a malfunction or damage to the copier. Always use the special feeder to feed paper when
you want to print onto the back of a sheet of paper that already has something copied on its
front side (2nd side of 2- Sided print).
• Use of the paper tray with the feeding support roller detached, may cause paper jams.
• Make sure that the size change plate is properly aligned with the marks of the desired paper
size. If the size change plate is not properly aligned, the paper tray may become damaged.
• Paper which has been rolled or curled must be straightened out before loading it into the
paper tray.
• Make sure that the height of the paper stack does not exceed the loading limit mark
inside of the paper tray.
NOTE
• The paper trays hold approximately 3,500 sheets of paper (80 g/m² / 22 lb bond).
• Only load the following sizes:
- 330.2 mm x 482.6 mm, 320 mm x 450 mm (SRA3), 304.8 mm x 457.2 mm, A3, B4, A4, A4R,
and B5 paper into the paper tray. Other than A4 paper cannot be loaded horizontally.
- 13" x 19", 12.60" x 17.72", 12" x 18", 11" x 17", LGL, LTR, or LTRR paper into the paper deck.
Only LTR paper can be loaded horizontally into the paper deck.
• For more information on the size change plate, see
module (optional) on page 122
• Hot air that is blown by the fan may warm the inner size change plate of the paper tray.
• If there are instructions on the package of paper about which side of the paper to load, follow
those instructions.
• When paper is loaded in the paper tray, the side facing up is the one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the paper stack over,
and reload it. However, you cannot turn the texture paper and 1-sided coated paper over.
Change the new paper.
5.
Lower the feeding support roller.
6.
Close the paper tray.
The inside lifter automatically rises, and prepares the paper tray for printing.
120 Chapter 7 - Media handling
Adjust the media size for the bulk media
on the