Clean the wire
Introduction
If streaks appear on printed output or parts of the printed image are missing, clean the corona
assembly wires inside the main unit.
NOTE
• It takes approximately 35 seconds to clean the wires.
• Wire cleaning cannot be performed during printing.
Procedure
1.
Touch [System] -> [Maintenance].
2.
Touch [Start maintenance].
3.
Touch [Clean the corona wires] and touch [Start]
A wizard opens.
4.
Touch [Next].
A status message displays.
5.
Touch [Finish].
6.
Touch [Stop] to close the [Maintenance tasks] menu.
NOTE
If the procedure displays an engine error, contact your local service representative.
.
Chapter 14 - Maintenance and print quality
Clean the wire
345