Perform A Curl Correction - Canon IMAGEPRESS C7011VPS SERIES Operation Manual

Perform a curl correction

Perform a curl correction
Introduction
Media can arrive curled in the output tray. This is caused by temperature differences during the
print process. You can perform a correction procedure to prevent curled sheets in the output
trays. The results of the correction are immediately effective for jobs that use these media.
For media that need a curl correction on the length and width, create two different entrances in
the media catalog. The correction procedure changes the media attributes in the media catalog,
so that the adjustments are applied to all jobs that use the same media. You can find the
correction values in the system adjustment settings of the Settings Editor (Preferences tab).
Before you begin
Make sure that all media attributes are correct in the media catalog.
Procedure
1.
Start the curl correction procedure from one of the following locations:
• The trays view:
1. Touch [Trays].
2. Select the tray with the media you want to register.
3. Touch [Optimize].
• The media catalog:
1. Touch [System] -> [Media].
2. Select a media from the [Media catalog].
2.
Touch [Curl correction].
3.
Define the correction.
Start with small increments to avoid paper jams.
4.
Touch [OK].
104 Chapter 7 - Media handling