Engine Oil And Filter Service - Polaris RZR 800 2013 Manual

MAINTENANCE

Engine Oil and Filter Service

Always change engine oil and filter at the intervals
outlined in the Periodic Maintenance Chart. Always
change the oil filter whenever changing the engine oil.
WARNING
Personal injury can occur when handling used oil. Hot
oil can cause burns or skin damage.
Recommended Engine Oil / Filter:
PS-4 Synthetic 4-Cycle Engine Oil
(PN 2876244) (Quart)
Engine Oil Filter (PN 2540086)
Capacity: 2 Quarts (1.9 L)
1. Position vehicle on a level surface.
2. Place the transmission in PARK (P).
3. Start the engine. Allow it to idle for two to three
minutes until warm. Stop the engine.
4. Clean area around oil drain plug at bottom of engine.
Oil may be hot. Do not allow hot oil to come into contact
with skin, as serious burns may result.
2.16
CAUTION
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
5. Place a drain pan beneath engine crankcase and
remove the drain plug.
6. Allow oil to drain completely.
7. Replace the sealing washer on drain plug.
NOTE: The sealing surface on the drain plug
should be clean and free of burrs, nicks or
scratches.
8. Reinstall drain plug and torque to specification.
Crankcase Drain Plug:
16 ft-lbs (22 Nm)
9. Place shop towels beneath oil filter. Using Oil Filter
Wrench (PU-50105) and a 3/8" extension, turn the oil
filter counter-clockwise to remove it.
Oil Filter Wrench:
PU-50105: 2.5" (64 mm)
10. Using a clean dry cloth, clean filter sealing surface
on the crankcase.
11. Lubricate O-ring on new filter with a film of fresh
engine oil. Check to make sure the O-ring is in good
condition.