Acura 1994 Integra Service Manual page 1099

A/C Compressor Belt
Replacement
Automatic Transmission Type
1. Loosen the adjust pulley bracket pivot bolt and the
adjusting bolt, then remove the A/C compressor
belt from the oullevs.
2, Remove the two mounting bolts from the left front
engine mount, then pass the A,/C compressor belt
through the gap between the body and left front
en9rne mount.
ADJUSTING BOLT
ADJUST PULLEY BRACKET
PIVOT BOLT
10 x 1.25 mm
54 N.m (5.5 kgf.m,
4(' rbr.ft)
Install in the reverse order of removal, and adjust
the A,/C compressor belt (see page 22-36).
"t.M'
22-35
- l
a ar-
Manual Transmission Type
1. Loosen the adjust pulley bracket pivot bolt and the
adjusting bolt, then remove the A/C compressor
belt from the pullevs.
2. Remove the two mounting bolts from the left front
engane mount.
Remove the engine mount nut, washer, bolt and the
left front engine mount.
Remove the A,./C comoressor belt.
ADJUSTING BOLT
ADJUST PULLEY BRACKET
PIVOT EOLT
l ! l ' ,
I
14 x 1.25 mm
83 N.m 18.5 kgl.m.
61 tbf.ft)
LEFT FRONT
ENGINE MOUNT
1 2 x ' 1 . 2 5 m m
69 N.m {7.0 kgf.m,
51 tbf.ftt
WASHER
Install in the reverse order of removal, and adjust
the Ay'C compressor belt (see page 22-36).
N O T E : W h e n t i g h t e n i n g t h e e n g i n e m o u n t n u t ,
make sure the washer is set properly on the left
front engine mount as shown.
10 x 1.25 mm
54 N.m (5.5 kgtm, irc lbf.ft)