Acura 1994 Integra Service Manual page 77

Gylinder Head
Removal
I
t
Engine removal is not required for this procedure.
CAUTION: To avoid damaging tho cylinder head, wait
until tho ongino coolant temporature drops bolow 100"F
{38"C) beforo loo36ning the rotainin0 bolts.
NOTE:
. Inspect the timing belt before removing the cylinder
neao.
. Turn the crankshaft pulley so that the No. 1 piston is
at top dead center (TDCI (page 6-12).
. Mark all emissions hoses before disconnecting them.
. Anti-theft radios have a coded theft protection circuit.
Be sure to get the customer's code number before.
-
Disconnecting the battery.
-
Removing the No. 32 (7.5 A) fuse irom the under-
hood fuse/relay box.
-
Removing the radio.
After service, reconnect oower to the radio and turn it
o n .
When the word "CODE" is displayed, enter the cus-
tomer's 5-digit code to restore radio operation.
1. Disconnect the negative terminalfrom the battery.
2.
Drain the engine coolant (see page 10-5).
. Remove the radiator cap to speed draining.
3.
Relieve fuel pressure (see Section 1 1).
@
Do not smoke whils working on tusl
systom, keep opon flame or spark away trom work
area. Drain fuol only inlo an approvod containsr.
4. Disconnect the fuel feed hose.
SERVIC€ BOLT
WASHERS
Replace.
5, Remove the intake air duct.
Remove the breather
evaporative emission
hose, water bypass hose and
(EVAP) control canister hose.