Ford 2002 Bantam Workshop Manual page 1146

412-00-53
GENERAL PROCEDURES (CONTINUED)
E4466 EN
Climate Control System — General Information
9. CAUTION: The maximum pressure of
13.5 bar must not be exceeded.
Use the tyre inflator to apply pressure of 5.5
to 10 bar (operating pressure) to the spray
gun.
10. Insert the spray gun hose as far as possible
into the opening in the heater blower,
working towards the evaporator (Mondeo
heater housing shown).
• By moving the hose, spray the odor
eliminating agent over the entire surface
of the evaporator.
• Spray the entire odor eliminating agent
into the opening.
• Allow the odor eliminating agent to take
effect for 10 minutes.
11. Install the components in reverse order.
12. Start the engine, switch off the air
conditioning system and ventilate the
vehicle for approx. 15 minutes. While this is
being done, have all ventilation nozzles
open, the temperature switch set to
maximum heat, the heater motor switch to
the highest position and the ventilation to
"fresh air".
13. Switch off the engine.
14. Connect the low pressure switch connector.
15. Ventilate the vehicle with the doors open for
another 30 minutes.
412-00-53
07/2001 2002 Bantam