Ford 2002 Bantam Workshop Manual page 1476

BACK TO CHAPTER INDEX
501-11-4
DIAGNOSIS AND TESTING (CONTINUED)
A4: CHECK FOR CONTINUITY BETWEEN THE DRIVER POWER WINDOW CONTROL SWITCH
AND THE DRIVER POWER WINDOW MOTOR UP CIRCUIT
A5: CHECK FOR CONTINUITY BETWEEN THE DRIVER POWER WINDOW CONTROL SWITCH
AND GROUND
1.
E9411 EN
Glass, Frames and Mechanisms
CONDITIONS
2.
Driver Window Con-
trol Switch C55a
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between the driver
power window control switch C55a pin 1, circuit
32-AJ26 (WH) and the driver power window
motor C106 pin 2, circuit 32-AJ26 (WH).
• Is the resistance less than 5 ohms?
Yes
GO TO A4
No
REPAIR circuit 32-AJ26 (WH). TEST the
system for normal operation.
1 Measure the resistance between the driver
power window control switch C55a pin 7, circuit
33-AJ26 (YE) and the driver power window
motor C106 pin 1, circuit 33-AJ26 (YE).
• Is the resistance less than 5 ohms?
Yes
INSTALL a new motor. TEST the system for
normal operation.
No
REPAIR circuit 33-AJ26 (YE). TEST the
system for normal operation.
3 Measure the resistance between the driver
power window control switch C55a pin 3, circuit
31-AJ7 (BK) harness side and ground.
• Is the resistance less than 5 ohms?
Yes
REPAIR circuit 14-AJ7 (VT/BU). TEST the
system for normal operation.
No
REPAIR circuit 31-AJ7 (BK). TEST the sys-
tem for normal operation.
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
501-11-4
CONTINUED
08/2001 2002 Bantam