Ford 2002 Bantam Workshop Manual page 1488

BACK TO CHAPTER INDEX
501-11-16
REMOVAL AND INSTALLATION (CONTINUED)
E6779 EN
Glass, Fram es and Mechanisms
5. NOTE: Discard the first 100 mm of PU 5. NOTE: Discard the first 100 mm of PU
adhesive as this may have a reduced working adhesive as this may have a reduced working
time. time.
NOTE: To avoid water leaks, any breakage in NOTE: To avoid water leaks, any breakage in
the continuous bead should be overlapped by the continuous bead should be overlapped by
20 mm. 20 mm.
6. NOTE: Firmly and evenly press in position;
tape the glass in the correct position until the
PU adhesive has cured.
7. Should the ambient temperature fall below
8. Install the C pillar trim cover.
FORD BANTAM
Apply the PU adhesive in a continuous Apply the PU adhesive in a continuous
bead of between 8 and 10 mm height to the bead of between 8 and 10 mm height to the
rear window glass along the bond line.
10°C, use a hot air gun at a distance of
approximately 50 mm from the surface and
apply warm air (25°C) continuously for 15
minutes (inside or outside the vehicle).
08/2001 2002 Bantam
PAGES FROM MANUAL
TO MODEL INDEX
501-11-16
CONTINUED