Air Conditioning (A/C) Clutch Air Gap Adjustment (34 628 6) - Ford 2002 Bantam Workshop Manual

412-00-40
GENERAL PROCEDURES

Air Conditioning (A/C) Clutch Air Gap Adjustment (34 628 6)

Material
Spacer washer set
E3640 EN
Climate Control System — General Information
Specification
1. Check the air gap A between the drive plate
and the pulley at 60 degrees intervals
around the circumference. For additional
information,
refer to Specifications. in this section
1. Belt pulley
2. Spacer washer
3. Drive plate
NOTE: The refrigerant circuit can remain closed
if possible.
2. If the air gap A is outside the tolerance
range, if necessary detach the air
conditioning compressor. For additional
information, refer to Section 412-02/ 412-03.
• Tie up the compressor with wire if
necessary.
3. Detach the drive plate.
4. Correct air gap A as necessary using
spacer washers.
5. Attach the drive plate.
6. Check air gap A as described in step 1.
Repeat steps 3-6 if necessary.
7. Install the air conditioning compressor.
For additional information,
refer to Section 412-02 / 412-03.
412-00-40
07/2001 2002 Bantam