Stop Lamps Are On Continuously - Ford 2002 Bantam Workshop Manual

BACK TO CHAPTER INDEX
417-01-31
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST J: STOP LAMPS ARE ON CONTINUOUSLY
J1: CHECK THE STOP LAMP SWITCH
1.
E6752 EN
CONDITIONS
CONDITIONS
2.
Stop lamp switch
C50
Exterior Lighting
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between rear lamp
assembly, left-hand side, connector C39,
circuit 31-LF23 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
Yes
CHECK the rear lamp assembly, left-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
No
REPAIR the open circuit(s) between rear
lamp assembly, left-hand side and ground
G4, by using the wiring diagrams. TEST the
system for normal operation.
DETAILS/RESULTS/ACTIONS
3.
• Are the stop lamps on continuously?
Yes
REPAIR the short to power; circuit(s)
connected with splice S37, by using the
wiring diagrams. TEST the system for
normal operation.
No
INSTALL a new stop lamp switch. TEST the
system for normal operation.
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
CONTINUED
07/2001 2002 Bantam
417-01-31