Rear View Mirrors - Ford 2002 Bantam Workshop Manual

501-09-2
DIAGNOSIS AND TESTING

Rear View Mirrors

Refer to Wiring Diagrams
Cell: 50109, Rear View Mirrors
for schematic and connector information.
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical and electrical damage.
Visual Inspection Chart
Mechanical
Exterior mirror(s)
Symptom Chart
Condition
• The mirrors are inoperative
• A single mirror is inoperative
• A single mirror does not function
with switch logic
Pinpoint Test
NOTE: Use a digital multimeter for all electrical
measurements.
07/2001
Rear View Mirrors
Electrical
Fuse(s)
Possible Sources
• Exterior mirror control switch.
• Circuit(s).
• Exterior mirror control switch.
• Circuit(s).
• Exterior mirror motor(s).
• Exterior mirror control switch.
• Circuit(s).
• Exterior mirror motor(s).
Mechanical
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
• CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Go To Pinpoint Test A
• CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Go To Pinpoint Test B
• CARRY OUT the Exterior Mirror
Control Switch Component Test.
REFER to the Wiring Diagrams.
• Go To Pinpoint Test C
501-09-2
Electrical
Relay
Electrical connector(s)
Switch
Action
2002 Bantam