Hydraulic Tappet Inspection; Cylinder Head Removal - Honda 1985 CBX750F Workshop Manual

~HONDA
CYLINDER HEAD/VALVES
~
CBX7S0F
HYDRAULIC TAPPET
Inspect the hydraulic tappet for wear or damage or
for a clogged oil hole.
CAUTION ;
­.
~
.
~
. '
• Never attempt to disassemble the tappets.
• Always use the special tool when bleeding
the tappets. Use of wire can cause damage
to them
Measure the free length of each hydraulic tappet as
follows:
Attach the Hydraulic Tappet Bleeder to the hydrau ­
lic tappet and compress and extend the hydraulic
tappet slowly in a jar filled with kerosene.
NOTE:
Hold the hydraulic tappet upright while com­
pressing and extending the hydraulic tappet.
Continue operating the hydraulic tappet until there
are no air bubbles from the hydraulic tappet and it
does not make no further action.
Remove the hydraulic tappet and try to compress
qu ickly the tappet by hand. Measure the compres­
sion stroke with the dial gauge on the flat place.
. COMPRESSION STROKE: 0-0.2 mm
NOTE:
Keep the hydraulic tappet below the surface
of kerosene while priming the hydraulic
tappet.
CYLINDER HEAD REMOVAL
Remove the following parts:
- carburetor (section 4).
exhaust system (section 5).
- hydraulic tappets (page 6-7).
Remove the four cam chain tensioner mounting
bolts.
Is.
;O=;;OL)
(1) HYDRAULIC TAPPET
BLEEDER
(07973-M E90000)
.
~6.
J '
~
..
(3)
(2)
6-8