Honda 1985 CBX750F Workshop Manual page 217

HONDA
CBX7S0F
FRONT WHEEL/SUSPENSION/STEERING
Install a new bearing adjustment nut lock washer
..
~
al igning the tabs with the grooves in the nut. Bend
two opposite tabs down into the grooves.
NOTE :
DO NOT install a used bearing adjustment nut
lock washer.
(1) BEARING ADJUSTMENT NUT (2) LOCK WASHER
Finger tighten the lock nut all the way .
Hold the adjustment nut and further tighten the
lock nut within 90 degrees enough to align its
grooves w ith the lock washer tabs.
. Bend the lock washer
tabs
up into the 'lo ck "n u t ­
grooves.
(2) LOCK WASHE R TAB
(1) EXTENSION BAR
07716-0020500
Install the fork top bridge w ith the fork a ir joint
---.
..----:
and install the steering stem nut.
~' .
Temporarily install the front forks.
~/Ci ii,' i r,.
Tighten the steering stem nut.
TORQUE: 90-120 N·m
(9.0-12.0 kg-m. 65-87 ft-Ib)
Tighten the steering stem pinch bolt.
TORQUE: 20-30 N·m
(2.0-3.0 kq
-rn,
14-22 ft-Ib)
_~~~
· -
i : i ? :
. . . ,
(2) LOCK NUT WRENCH, 30 x 32 mm
07716-0020400
13-37