Honda 1985 CBX750F Workshop Manual page 142

--------------------------------------
--
HONDA
CBX750F
CRANKCASE
,­
Clean the crankcase mating surface and apply liquid
sealant to the mating surface of the lower crankcase.
.~
..
CAUTION
Do not apply sealant to the area near the
.
main bearings and tapered holes.
k
- " ,
I
iOO
~JOT CO~T
THIS
.. 11
hRE":'.
10.0'"
,r,'
1
rnrn
'-------_J
Install two crankcase assembly pins (07973­
ME50000) into the upper crankcase taper holes.
Shift the gearshift linkage into neutral for easier
assembly, if the gearshift linkage is installed in the
. -- lower crankcase..
Install the lower crankcase over the upper crank­
case, aligning the shift fork cawls with the shift fork
grooves.
(2) CRANKCASE ASSEMBLY PIN
07973-M E50000
Tighten the crankcase assembly pins with 6 x 15
mm bolts.
Apply molybdenum disulfied grease to the 8 mm
crankcase bolt threads and flanges.
Tighten the lower crankcase bolts in the sequence
/
shown in 2·3 steps.
TORQUE:
8mm BOLTS:
21-25 N·m (2.1-2.5 kg·m, 15-18 ft-lb)
6mm BOLTS:
10-14 N·m (1.0-1.4 kg·m, 7-10 ft-lb)
Loosen the 6 x 15 mm bolts several turns and tap
the bolt heads with a hammer. Remove the bolts
and pins.
"
UPPER
CRANK­
ICASE
~
-=(1)
i
(3)
I
LOW E R
CRANK­
ICASE (4)
10-4