Fuel Valve; Engine Oil; Viscosity; Pre-Riding Inspection - Honda CBX 750F RC17 Manual

Fuel Valve

The fuel valve (1) is located under the left side of the fuel tank. With the valve set in the
"OFF" position, fuel supply is cut off. The valve should be set in this position when the
motorcycle is not in use.
Turn to the "ON" position for normal riding (gasoline will flow to the carburettors).
Turning the fuel valve to the "RES" position allows fuel to flow from the reserve supply.

Engine Oil

Good engine oil has many desirable qualities. Use only high detergent, quality motor oil
certi fied on the container to meet or exceed requirem ents for service SE or SF. It is not
necess ary to use additives.

Viscosity

Viscosity grade of engine oil should be based on average atmospheric temperature in
your riding area. The following provides a guide to the selection of proper grade or
viscosity of oil to be used at various atmospheric temperatures.

PRE-RIDING INSPECTION

Prior to starting your motorcycle, perform a general inspection as a matter of habit to make sure that the motorcycle is in good,
safe riding condition.
Check the following items and if adjustment or servicing is necessary, refer to the appropriate section in the manual.
Engine oil level:
Fuel Level:
Brakes:
Tyres:
Battery electrolyte:
Throttle operation:
Lighting:
Drive chain:
STARTING THE ENGINE
NOTE: The electrical system is designed to prevent electric starting if the transmission is in gear, unless the clutch is
disengaged. However it is recommended that the transmission be placed in neutral before attempting to start the engine.
WARNING: Exhaust gases contain poisonous carbon monoxide. Never run the engine in
a closed garage or confined area.
1. Make sure the transmission is in neutral and the fuel valve is ON.
2. Insert the key in the ignition switch and turn to ON. The neutral indicator (green) and
oil pressure light (red) should go on.
3. Make sure the engine stop switch is in the run position.
4. Pull the choke lever (1) all the way to the fully open position (A), if the engine is
cold.
All manuals and user guides at all-guides.com
Check the level and add if necess ary.
Fill tank when necessary.
Check the brake lines for leaks, check brake fluid level.
Check the air pressure and tyres for wear or damage.
Check the level and add if necess ary.
Check throttle operation, cable routing and free play.
Correct or replace i f necessary.
See if all lights operate properly.
Check condition of drive train and measure the chain tension. Adjust if the chain tension is
incorrect. Lubricate if it appears dry. Replace if it is badly worn or damaged.
13