Honda 1985 CBX750F Workshop Manual page 197

HONDA
CBX7S0F
FRONT WHEEL/SUSPENSION/STEERING
Apply molybdenum disulfied grease to the dust sea l
lips and install the dust seal.
Place new gaskets on the disc mounting flange, then
install the right disc with its "R" mark facing out.
Tighten the mounting bolt to the same torque as
left side.
Install the spacer.
Fill the speedometer gearbox with grease and install
the plain washer and drive gear.
Install the speedometer gearbox in the wheel hub,
aligning the tangs with the slots. - - - - - - ­
_
Install the front axle and axle nut. Tighten the axle
nut.
TORQUE: 55-65 N'm
(5.5-6.5 kq-m, 40-47 ft-Ib]
NOTE :
There are flats on the opposite end of the
axle, so you can hold the axle while torquing
the axle nut.
Clean the brake discs with a high quality degreasing
agent.
~
R
(3) DUST SEAL
(1)
DRIVE GEAR
~
(3) WASHER
(4) TANGS (5) SLOTS
13-17