Rear Master Cylinder Assembly; Rear Master Cylinder Installation - Honda 1985 CBX750F Workshop Manual

HONDA
CBX7S0F
HYDRAULIC BRAKES
ASSEMBLY
CAUTION
Keep the master cylinder piston. cylinder and
spring as a set; do not substitute individual
parts:
Assemble the master cylinder. Coat the master pis­
ton. primary and secondary cups with clean brake
fluid before assembly. Install the spring and primary
cup together.
Install the piston.
Install the push rod and snap ring.
CAUTION
Do not allow the lips 01 the cups to turn in­
side out and be certain the snap ring is firmly
seated in the groove.
(2) PISTON
~
13) PUSH ROO
X
~ ~ ~
(1) BRAKE FLUID
, . DOT4
~ .&~~ ~
~(f(j)Y@~
Install the rubber boot.
INSTALLATION
(1) PUNCH MARKS
(2) RETURN SPRING
Install the master cylinder onto the footpeg bracket.
Connect the actuating arm to the master cylinder
push rod with the joint pin. washer and a new cotter
pin.
Install the actuating arm onto the pedal shaft. align­
ing the punch marks on the arm and shaft.
Tighten the actuating arm bolt.
Hook the rear brake return spring to the actuating
arm.
(3) ACTUATING ARM BOLT
(1) RESERVOIR JOINT HOSE
Connect the reservoir joint hose to the master cylin­
der with a new D-ring and the screw.
15-17