Shock Absorber Installation - Honda 1985 CBX750F Workshop Manual

~HONDA
~
CBX7S0F
REAR WHEEL/SUSPENSION
Install the back-up ring.
(1) STOP RING
Install the stop ring, being certain that it is seated in
the ring groove in the outer case.
NOTE:
Be sure stop ring is seated in the ring groove
all the way around.
Install the boot.
(2) BACK·UP RING
Install the boot clip with the, edge facing down.
(1) ADJUSTE R
(2)
Install the damping adjuster cable bracket onto the
absorber.
Apply locking agent to the threads of the attaching
screws and secure the bracket with the screws.
Connect the adjuster-cable to the adjuster and
secure it with the washer and new cotter pin.
INSTALLATION
(1) ABSORBER UPPER MOUNTING BOLT
Apply paste grease (containing more than 45% of
molybdenum) to the upper and lower mounting
bushings.
NOTE:
(3) BRACKET
(4) ATTACHING SCREWS
Use paste grease (containing more than 45%
of molybdenum) as follows:
• MOLYKOTE G-n PASTE manufactured by
Dow Corning, U.S.A.
• Locol Paste manufactured by Sumico
Lubricant, Japan.
• Other lubricants of equivalent quality.
Install the shock absorber in the frame and tighten
the upper and lower mounting bolts.
TORQUE: 40-50 N'm
(4.0-5.0 kg·m, 29-36 ft-lb)
14-13