Shift Register (Sio) And Internal Bus Configuration - NEC PD75402A User Manual

(5) Data transfer order
The PD75402A 3-wire serial I/O mode differs from that of other 75X series products in that it is not possible to
switch between MSB and LSB as the first bit.
Serial transfer is performed MSB-first.
Fig. 5-31 Shift Register (SIO) and Internal Bus Configuration
(6) Start of transfer
When the following two conditions are met a serial transfer is started by setting transfer data in the shift register
(SIO).
• The serial interface operation enable/disable bit (CSIE) = 1.
• After an 8-bit serial transfer, the internal serial clock is stopped or SCK is high.
Note The transfer will not be started if CSIE is set to "1" after data is written into the shift register.
When an 8-bit transfer ends, the serial transfer stops automatically and the IRQCSI interrupt request flag is set.
Example In the following example the data in the RAM specified by the HL register is transferred to SIO, and at
the same time the SIO data is fetched into the accumulator and the serial transfer is started.
MOV XA, @HL ; Fetch send data from RAM
XCH XA, SIO ; Exchange send data with receive data and start transfer
90
CHAPTER 5. PERIPHERAL HARDWARE FUNCTIONS
7
6
Internal
Bus
1
0
Read/Write Gate
Shift Register (SIO)
SI
SO
SCK
SO Latch
D Q