Programming A Batch Transmission - Muratec F-320 Operating Instructions Manual

Advanced features
8
Press . The shows:
ENTER LCD
Enter Sub-Address
_
9
Use the numeric keypad to enter the
you want to poll the document.
10
Press . The shows:
ENTER LCD
Enter Password
_
Note: If there isn't a password for this box, skip to step 12.
11
Use the numeric keypad to enter the appropriate
12
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
13
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length.
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or
14
If you want the polling to begin immediately every time you press the key,
press and proceed to step 11.
ENTER
If you want to delay the polling, follow steps 7–9 on page 3.33. Then press
, .
ENTER ENTER
15
Press to return your machine to standby mode.
STOP

Programming a batch transmission

For this operation to work, two things must be true:
• The batch box you're using must exist on your fax machine.
• You must know the batch box's identifier number (1–5).
To program a batch transmission into a programmable one-touch key:
1
Press , 3, 4, 1,
MENU ENTER
touch number available:
Select Program No.
58:No Number Stored
3.38
- sub-address for the box from which
ITU T
- password for the box.
ITU T
to scroll to the right.
. The shows the first empty programmable one-
LCD
2
Press or to select the programmable one-touch key in which you want to
store or change.
Note: You can select the one-touch key by pressing that key on the control
panel.
3
If you selected the empty programmable one-touch key, proceed to step 4.
If you selected the key already programmed and you want to change it, skip
to step 6.
Note: If your previous command for this key was a batch transmission and
you want to keep this key programmed a batch transmission, use these
instructions to make changes. But if the previous command for this
key was a different command, you must first erase the stored com-
mand (see page 3.41) before programming the new one.
4
Press . The shows:
ENTER LCD
Type :Communication
$ $ # #
/ /Enter
5
Press or until "Communication" appears.
6
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
7
Press . five times. The
COMM OPTIONS
5.Batch Tx
$ $ # #
/ /Enter
8
Press . The shows:
ENTER LCD
Batch Tx
Enter Box No.
9
Use the numeric keypad to enter the one-digit identifier for the batch box you
want.
Note: To change an identifier already entered, press
Then re-enter the correct identifier.
shows:
LCD
:_
to erase it.
CANCEL