Muratec F-320 Operating Instructions Manual page 66

5
The standby display appears and the machine begins to beep which indi-
LCD
cates the machine is in the
MACRO
Fax Ready
Jan 27 2002 1:30pm
6
Press the keys exactly as though you were programming a current job. The
machine will beep during programming to confirm
Note: You can program up to 60 steps. When it comes over 60 steps, your fax
machine asks if you want to register the operations you have entered.
If you want to register them, press
Note: If you want to cancel the operations you have set, press
,
MACRO PROGRAM STOP
Example 1: To program some operations for copy: Press
copy mode, and set number of the copies, contrast, document mode and reduc-
tion rate as you want.
Note: See "Making copies" (pages 2.11–2.12) for detail operations.
Example 2: To program the operations for printing the one-touch numbers
list: Press , 5, 1, 0, 5,
MENU ENTER
7
If you programmed or
ENTER START
Otherwise, press
MACRO PROGRAM
8
If you want to start immediately after pressing the Macro key when you use
it, press . If not, press
ENTER CANCEL
Include Start/Enter?
Yes Enter
Note: If you want to confirm the settings or operations in the Macro key
before you start it, press
9
The now shows:
LCD
M2:Name ;Upper
_
The machine now asks you to enter the title of this job.
If you do not want to enter or change it, skip to step 11.
10
Enter the title by using the numeric keypad. (If necessary, review "Entering
characters", page 1.12) It may be up to 130 characters in length.
11
Press to save the setting.
ENTER
programming mode.
programming mode.
MACRO
. If not, press
ENTER STOP
and then go back to step 1.
to change to the
COPY
.
into the operation, proceed to step 8.
and skip to step 9.
.
Include Start/Enter?
No Cancel
here.
CANCEL
Fax dialing with the Macro key
To dial a fax call using a Macro key:
1
Insert the document.
2
Press the Macro key in which you've stored the fax communication com-
mand.
3
Press
START
Your fax will perform the operation now, or at whatever time you programmed.
. If you programmed this key to delay its operation, the
** Reserved **
Jan 27 2002
If you programmed this key to perform the operation immediately after you press it,
the shows the number:
LCD
9-1-972-555-4335
A4 Normal
Copying with the Macro key
To copy using a Macro key:
1
Insert the document.
2
Press the Macro key in which you've stored the copy command.
3
Press
START
Printing lists using the Macro key
To print a list using a Macro key:
1
Press the Macro key that is programmed for the printing lists.
2
Press
ENTER
, if you have not registered in the Macro key.
START
5:17pm
, if you have not registered in the Macro key.
START
, if you have not registered in the Macro key.
ENTER
Advanced features
shows:
LCD
3.17