Settings For Transmission; Scan Settings; Setting Ecm - Muratec F-320 Operating Instructions Manual

Settings for transmission

Scan settings

Default setting: Primary document mode: Normal, Primary contrast: Normal
Two different settings tell your machine how to scan documents. The initial factory
settings are probably right for most applications, so try using them before changing
any of these settings:
• Primary document mode — Sets the document mode for your documents.
Choose either normal, fine, superfine ("S-Fine" on the
("Gray").
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
Note: These settings you choose effect your fax activity only.
To set these modes:
1
Press , 2, 2, 0, 1, . The
MENU ENTER
Document Mode:Normal
$ $ # #
/ /Enter
2
Press or until the mode you want appears.
3
Press to save the setting. The
ENTER
Contrast :Normal
$ $ # #
/ /Enter
4
Press or until the mode you want appears.
5
Press to save the setting.
ENTER
By following the steps above, you've set your defaults for scanning. Before sending
documents, you can "override" these default scan settings for that transmission.
To override the default document mode and contrast settings before sending a docu-
ment:
• Press to change the document mode.
DOCUMENT MODE
• Press to change the contrast.
CONTRAST
Once your document is transmitted, your machine returns to its default settings.
) or grayscale mode
LCD
asks you to select a document mode:
LCD
asks you to select a contrast setting:
LCD
Setting
ECM
Default setting: ON.
"Line noise," or static on the line during a call, can easily disrupt the flow of data
from one fax machine to another.
That's why your fax machine gives you the option of using Error Correction Mode
( ). When two fax machines communicate while running in
ECM
machine automatically checks the data as it sends. If the receiving fax machine can't
verify the transmission, the first machine will re-send it as necessary.
Note: gives you a better chance of transmitting a fax document over a bad
ECM
phone line, but it could also slow down the transmission time. The worse a
line is, the slower the transmission. That's why the machine lets you turn
on or off as needed.
ECM
Note: Not all fax machines have
ECM
a fax machine not currently using
transmission from a usual, non-
1
Press , 2, 2, 0, 9, . The
MENU ENTER
ECM Mode :On
$ $ # #
/ /Enter
2
Press or until the mode you want appears.
3
Press to save the setting.
ENTER
Changing the default settings
, the sending
ECM
. If you've activated and then transmit to
ECM
, there will be no change in the fax
ECM
transmission.
ECM
shows the current setting:
LCD ECM
4.1