Settings For Dialing; Changing The Dialing Pause Length; Changing Redial Settings - Muratec F-320 Operating Instructions Manual

Settings for dialing

Changing the dialing pause length

Default setting: 2 seconds.
The pause is set by the factory to last two seconds, but you can set it to last as long
as ten seconds if necessary. To change the pause length:
1
Press , 2, 2, 0, 5, . The
MENU ENTER
Dialing Pause
(02-10) 02 sec.
2
Use the numeric keypad to enter the length you want for the dialing pause.
Note: The length setting requires two digits. Always enter a leading zero for
lengths less than 10 seconds.
3
Press to save the setting.
ENTER
shows:
LCD

Changing redial settings

Default setting: Number of redial: 2 times, Redial interval: 1 minute.
It's up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval).
To program the redial settings:
1
Press , 2, 2, 0, 4, . The
MENU ENTER
# Of Redials
(02-15) 02 times
2
Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 15 redials.
Note: Enter a leading zero when entering a quantity less than 10.
3
Press to save the setting.
ENTER
4
The now shows:
LCD
Redial Interval
(1-5) 1 min.
5
Use the numeric keypad to enter the length you want between redial
attempts. Choose from 1 to 5 minutes.
6
Press to save the setting.
ENTER
Changing the default settings
shows:
LCD
4.5