Muratec F-320 Operating Instructions Manual page 86

10
Press . The shows:
ENTER LCD
Enter Password
_
Note: If there isn't a password for this box, skip to step 12.
11
Use the numeric keypad to enter the appropriate
12
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
13
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length.
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or
14
If you want the transmission to begin immediately every time you press the
key, press and proceed to step 15.
ENTER
If you want to delay the transmission, follow steps 7–9 on page 3.33. Then
press , .
ENTER ENTER
15
The now asks if you want to make additional settings for this program-
LCD
mable one-touch number.
Option :Off
$ $ # #
/ /Enter
If you do not want to make additional settings, select "Off" and press
Then skip to step 17.
If you do want to make additional settings, press
.
ENTER
16
Follow steps 13–25 on page 3.34.
17
Press to return your machine to standby mode.
STOP
- password for the box.
ITU T
to scroll to the right.
.
ENTER
to select "On" and press
Programming F-Code polling
For this operation to work, two things must be true:
• The document which you're polling must exist in the remote fax's F-Code box (
standard sub-addressing/password box).
• You must know the remote fax's
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1
Press , 3, 4, 1, . The
MENU ENTER
touch number available:
Select Program No.
58:No Number Stored
2
Press or to select the programmable one-touch key in which you want to
store or change.
Note: You can select the one-touch key by pressing that key on the control
panel.
3
If you selected the empty programmable one-touch key, proceed to step 4.
If you selected the key already programmed and you want to change it, skip
to step 6.
Note: If your previous command for this key was a F-Code polling and you
want to keep this key programmed a F-Code polling, use these instruc-
tions to make changes. But if the previous command for this key was a
different command, you must first erase the stored command (see page
3.41) before programming the new one.
4
Press . The shows:
ENTER LCD
Type :Communication
$ $ # #
/ /Enter
5
Press or until "Communication" appears.
6
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
7
Press . four times. The
COMM OPTIONS
4.F-Code Polling
$ $ # #
/ /Enter
Advanced features
- sub-address and password (if any) for each
ITU T
shows the first empty programmable one-
LCD
shows:
LCD
-
ITU T
3.37