Muratec F-320 Operating Instructions Manual page 85

Advanced features
4
Press . The shows:
ENTER LCD
Type :Communication
$ $ # #
/ /Enter
5
Press or until "Communication" appears.
6
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
7
Press . twice. The
COMM OPTIONS
2.Polling
$ $ # #
/ /Enter
8
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
9
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length.
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or
10
If you want the polling to begin immediately every time you press the key,
press and proceed to step 11.
ENTER
If you want to delay the polling, follow steps 7–9 on page 3.33. Then press
, .
ENTER ENTER
11
Press to return your machine to standby mode.
STOP
Programming an F-Code transmission
For this operation to work, two things must be true:
• You must know how the remote fax is using each F-Code box to which you're
transmitting — for example, as a security box or a relay box. Different fax manu-
facturers may use slightly different terms, but the concepts are the same.
• You must know the remote fax's
which you want to transmit.
3.36
shows:
LCD
to scroll to the right.
- sub-address and password for each box to
ITU T
To program an F-Code transmission into a programmable one-touch key:
1
Press , 3, 4, 1, . The
MENU ENTER
touch number available:
Select Program No.
58:No Number Stored
2
Press or to select the programmable one-touch key in which you want to
store or change.
Note: You can select the one-touch key by pressing that key on the control
panel.
3
If you selected the empty programmable one-touch key, proceed to step 4.
If you selected the key already programmed and you want to change it, skip
to step 6.
Note: If your previous command for this key was a F-Code transmission and
you want to keep this key programmed a F-Code transmission, use
these instructions to make changes. But if the previous command for
this key was a different command, you must first erase the stored com-
mand (see page 3.41) before programming the new one.
4
Press . The shows:
ENTER LCD
Type :Communication
$ $ # #
/ /Enter
5
Press or until "Communication" appears.
6
Press . The shows:
ENTER LCD
58:Fax#/Comm.Options
_
7
Press . three times. The
COMM OPTIONS
3.F-Code Tx
$ $ # #
/ /Enter
8
Press . The shows:
ENTER LCD
Enter Sub-Address
_
9
Use the numeric keypad to enter the
you want to send the document.
shows the first empty programmable one-
LCD
shows:
LCD
- sub-address for the box to which
ITU T