Muratec F-320 Operating Instructions Manual page 93

Advanced features
2
Use the numeric keypad to enter the four-digit passcode.
Note: If you enter an invalid passcode, the machine's security feature rejects
the attempt and returns to standby mode.
3
Press . The shows:
ENTER LCD
PIN Mode
$ $ # #
/ /Enter
4
Press or until the mode you want appears.
PIN Mode
$ $ # #
/ /Enter
5
Press .
ENTER
Autodialing while using the
Note: The following instructions presume you understand how to set and use your
machine's autodialer. If you need to review, see pages 3.1–3.7.
If you chose "Mode 1" — the
PIN
In Mode 1, before autodialing a number for the first time, you must add the
the stored one-touch key or speed-dial number. Here's how:
1
Begin by creating or changing an entry in the autodialer. See pages 3.1–3.7 if
necessary. While you're setting this up, the machine asks you to enter the
The shows:
LCD
Set PIN Number
Enter Passcode :****
2
Use the numeric keypad to enter the four-digit passcode.
3
Press . The shows:
ENTER LCD
001:PIN Number
_
4
Use the numeric keypad to enter the desired
length.
5
Press to save the
ENTER PIN
Note: If you press
ENTER
indicates "Invalid Number" on the
Now you may autodial the number as usual.
3.44
:Off
:Mode1
mask
PIN
goes in
, up to eight characters in
PIN
.
without entering the , the fax machine beeps,
PIN
and then returns to step 4.
LCD
Important: While in
the
PIN
transmission (see pages 3.11–3.13) or programmable one-touch keys
(see pages 3.33–3.41).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission,
you must store the
ate batch box.
If you chose "Mode 2" — as you autodial, load the code
In this mode, you don't have to add the
enter the manually each time you autodial:
PIN
1
Dial the number as you normally would, using the autodialer. The machine
now asks for the
Enter PIN Number
_
2
Use the numeric keypad to enter the
Enter PIN Number
1057_
to
PIN
3
Press . Your machine dials the number.
START
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 3.11–3.13), you must store the
.
PIN
within the appropriate batch box.
Dialing from the numeric keypad while using the
If you've specified Mode 1 — use "star" power
1
Enter the phone number, then press the * ("star") key and enter the
The always goes last. For example, to dial 19725550911 with a
PIN
"123456", enter 19725550911*123456:
Press Start
19725550911*123456_
2
Press . The
START
desired phone number.
Mode 1, any autodialer numbers you use must include
PIN
. This also applies to autodialer numbers used with batch
access code for the remote unit within the appropri-
PIN
to the autodialer setting. Instead, you
PIN
:
PIN
.
PIN
access code for the remote unit
PIN
disappears from the display, and your machine dials the
PIN
mask
PIN
.
PIN
of
PIN