Muratec F-320 Operating Instructions Manual page 20

Setting of the Paper Size
Default setting: Ltr (Letter-sized paper)
When you change the size of paper in the paper cassette, you must also change the
paper size setting, as shown below.
1
Press , 2, 1, 0, 1, . The
MENU ENTER
1st Cassette :Ltr
$ $ # #
/ /Enter
2
Press or until the recording paper size for the first cassette you want
appears.
3
Press . The shows:
ENTER LCD
Bypass Tray :Ltr
$ $ # #
/ /Enter
4
Press or until the recording paper size for the bypass tray you want
appears.
5
Press .
ENTER
Press to return to standby mode.
STOP
shows:
LCD
Loading paper in bypass tray
When you need to use a size of paper not currently loaded in your machine's paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
1
Open the bypass tray on the right
side of your machine.
2
Pull out the hopper of the bypass
tray and raise the flapper release
lever.
3
Place the paper on the bypass
tray. Adjust the paper guide to fit
the paper and insert the paper
until it comes to a stop.
Then lower the flapper release
lever.
4
When you load the paper on the bypass tray, the
paper size you've set. (See "Setting of the paper size," left column.)
Set Bypass Ppr:Ltr
$ $ # #
/ /Enter
5
Press or until your desired recording paper size appears.
Note: If you use transparency film, select "OHP".
6
Press .
ENTER
Note: If you have set the Letter
bypass tray, the machine will use them when it runs out of the paper in the
paper cassette during the fax reception.
will show the primary
LCD
, Legal , Half-letter sized paper in the
Getting started
1.9