Entering Characters - Muratec F-320 Operating Instructions Manual

Getting started

Entering characters

Some settings give you a chance to enter characters; for your TTI, remote fax's name
or others. To enter letters or other characters, use the following guidelines:
Using numeric keypad to enter characters
You can enter 40 letters, digits or symbols (and space) using the numeric keypad as
shown in the character table below.
Pressing the 2 numeric key once, for example, will enter an "A". Pressing 2 twice,
will enter a "B". If you want to enter "LA", for example, you would press 5, 5, 5, 2.
When you want to enter two characters that share the same numeric key ("D" and
"E", for example), press to move the cursor to the right after you enter the first
letter. For example, if you want to enter "ABC": press 2, , 2, 2, , 2, 2, 2.
Canceling characters
If you entered an incorrect letter or digit, press
change just one character in name and/or digit, press
that character or digit. Then press
digit correctly.
1.12
to erase to the left. To
CANCEL
or to move the cursor to
to erase it. Re-enter the character or
CANCEL
To change upper/lower case
Your Name ;Upper
_
Press #( ) key to toggle upper case and lower case.
CAPS
The word "Upper" means the machine will enter only upper-case letters.
To type a lower-case letter, press #(
CAPS
The changes to:
LCD
Your Name ;Lower
_
This means the machine will enter lower-case letters.
To switch back for upper-case entries, press #(
Entering the special characters
You can also enter special characters or symbols.
1
When the machine prompts you to enter a name, press * key.
The changes to:
LCD
· @- _ , / : & ' ! ?"# $ % ( ) +
$ $ # #
! ! " "
/ / / /Enter
2
Select the character you want to enter using , ,
3
To enter the character, press
ENTER
4
If you want to enter other character, repeat steps 1–3.
Otherwise, go to next step.
5
Press to save the name.
ENTER
) key.
) key again.
CAPS
or of cursor key.
key.