Fax Dialing Via Speed-Dial; Phoning Via Speed-Dial - Muratec F-320 Operating Instructions Manual

Fax dialing via speed-dial

To dial a fax call using a speed-dial number:
1
Place the document in the
ADF
2
Adjust document mode and contrast if necessary.
3
Press / once. The
SPEED DIAL GROUP
Enter Speed Dial No.
S_
4
Use the numeric keypad to enter the three-digit identifier (such as 018, in this
example) for the speed-dial number you want to dial. The
Location (or fax number) you stored:
ID
Plano Office
S018_
5
Press .
START
What happens next depends on whether you specified memory transmission or real
time transmission:
If you specified quick memory transmission:
• Your fax machine scans the first page of your document into memory, then dials
the other fax machine.
• While dialing, your machine scans the other documents into memory.
• The shows the Location , the document's width and document mode.
LCD ID
Note: If the speed-dial number doesn't have a Location
• When the other machine answers, your fax transmits the scanned document
directly from memory. (To review Quick memory transmission, see page 2.3.)
If you specified normal memory transmission:
• Your fax machine scans your entire document into memory, then dials the other
fax machine.
• The shows the Location , the document's width and document mode.
LCD ID
Note: If the speed-dial number doesn't have a Location
• When the other machine answers, your fax will transmit the document directly
from memory. (To review Memory transmission, see page 2.2.)
.
shows:
LCD
shows the
LCD
, the number appears.
ID
, the number appears.
ID
If you specified real time transmission:
• Your fax machine dials the other fax machine.
• The shows the Location , the document's width and document mode.
LCD ID
Note: If the speed-dial number doesn't have a Location
• When the other machine answers, your fax feeds the document through its scan-
ner, transmitting as it goes. (To review the Real time transmission, see page 2.3)

Phoning via speed-dial

To dial a phone call using a speed-dial number, you must have an optional handset
attached to your machine. To make the call:
1
Obtain a dial tone by doing one of the following:
• Lift the handset
• Press / to use the monitor speaker
MONITOR CALL
2
Press / once. The
SPEED DIAL GROUP
** Tel Mode **
S_
3
Use the numeric keypad to enter the three-digit identifier for the speed-dial
number you want to dial. As the machine dials, it shows the number on the
.
LCD
Note: Remember that your fax machine's monitor speaker is not a speakerphone.
If you dialed using the monitor speaker, pick up the handset to speak to the
person that answers!
Note: If the call fails, and you used
hang up.
Advanced features
, the number appears.
ID
shows:
LCD
/ to dial, press
MONITOR CALL MONITOR
/ to
CALL
3.5