Display Mask - Toshiba T1960CT Maintenance Manual

4.12 Display Mask

Removing the Display Mask
To remove the T1960CS/T1960CT's display mask, follow the steps below and refer to Figure
4-25.
1. Turn off the power to the computer, and, if attached, disconnect the AC adapter,
power cord and all external cables connected to the computer.
2. Remove the battery pack, optional memory card, optional PCMCIA card and top
cover as described in Sections 4.2, 4.3, 4.4 and 4.5.
NOTE: It is not necessary to remove the display assembly.
3. Remove the two screw covers from the display hinges to expose two screws
securing the display mask.
4. Remove the two M2.5x6 silver screws that were covered by the screw covers.
5. Carefully insert your fingers between the mask and the LCD panel and pry open
the latches. Start with the four latches across the top of the display mask.
6. Continue unlatching the mask along the sides (four latches on each side), at the
bottom (two latches), and display supports. There is also a latch at the small
support and three latches at the large support not indicated in the illustration.
T1960CS/T1960CT
Figure 4-25 Removing the Display Mask
4-29