Toshiba T1960CT Maintenance Manual page 131

4.11 Floppy Disk Drive and Mouse/KB Board
Removing the Floppy Disk Drive and Mouse/KB Board
To remove the T1960CS/T1960CT's floppy disk drive and mouse/KB board, follow the steps
below and refer to Figures 4-22 through 4-24.
1. Turn off the power to the computer, and, if attached, disconnect the AC adapter,
power cord and all external cables connected to the computer.
2. Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, keyboard, HDD, display mask, display assembly, upper system board, and
lower system board as described in Sections 4.2 through 4.7, 4.12, 4.8, 4.9, and
4.10.
3. Remove the two M2.5x6 silver screws on the mouse/KB board assembly
(Figure 4-22).
4. Lift the left side of the FDD unit with mouse/KB board assembly and slowly pull
it to the left to remove the assembly from the chassis (Figure 4-22).
Figure 4-22 Removing the FDD and Mouse/KB Board
5. To separate the mouse/KB board and FDD unit, remove the two M2.5x4 screws
(Figure 4-23).
Figure 4-23 Separating the FDD and Mouse/KB Board
T1960CS/T1960CT
4-27