Toshiba T1960CT Maintenance Manual page 136

Installing the T1960CS FL Inverter Board
To install the T1960CS's FL inverter board, follow the steps below and refer to Figures 4-26
and 4-27.
1. Connect the FL inverter cable to CN1 on the inverter board and the two FL
cables to CN2 and CN3 (Figure 4-27).
2. Route the cables so they are not pinched by the FL inverter board, display
hinge or other component.
3. Replace the FL inverter board and secure it with the two M2.5x6 screws (Figure
4-27).
4. Set the display support plate in place and secure it with four M2.5x6 screws.
One screw also secures the display ground cable (Figure 4-26).
5. Install the display mask, top cover, optional PCMCIA card, optional memory card
and battery pack as described in Sections 4.12, 4.5, 4.4, 4.3 and 4.2.
4-32
T1960CS/T1960CT