Toshiba T1960CT Maintenance Manual page 145

Installing the Liquid Crystal Display Module
To install the T1960CT's liquid crystal display module, follow the steps below and refer to
Figures 4-33 to 4-35.
1. Connect the display cables to the display cable board (Figure 4-35).
2. Connect the display cable board to the LCD module (Figure 4-34).
3. Fix the insulator to the board pressing gently to secure the tape.
4. Place the module in the cover and route the cables so they will not be pinched by
the display panel or other components.
5. Secure the panel with three M2.5x6 screws (Figure 4-33).
6. Install the FL inverter board, display mask, top cover, optional PCMCIA card,
optional memory card and battery pack as described in Sections 4.16, 4.12, 4.5,
4,4, 4.3 and 4.2.
T1960CS/T1960CT
4-41