Toshiba T1960CT Maintenance Manual page 84

(e) Track verification
A check is made of all tracks and if an ECC error, ECC-correctable-data
error or record-not-found error is detected at a track, that track is
formatted as a bad track automatically.
2. Good track FORMAT
If a good track has been erroneously formatted as a bad track, you can use
this subtest to reformat the track as a good track. To format a track as a
good track, enter the number for the drive, interleave, cylinder and head as
indicated in the screen prompts shown below.
Drive number select (1:#1, 2:#2) ?
Interleave number (1 / 1 - 8) ?
Press Enter to return to the Hard Disk Format menu.
3. Bad track FORMAT
To format a track as a bad track, enter the number for the drive, interleave,
cylinder and head as indicated in the screen prompts shown below.
Drive number select (1:#1, 2:#2) ?
Interleave number (1 / 1 - 8) ?
Press Enter to return to the Hard Disk Format menu.
4. Bad track CHECK
This subtest reads the entire disk and displays a list of bad tracks. The test is
terminated when a bad track check error occurs. To initiate the subtest, enter
the drive number at the prompt shown below.
Drive number select (1:#1, 2:#2) ?
Bad tracks will be displayed in the format shown below.
[[cylinder, head = 0123 03]]
Press Enter to return to the Hard Disk Format menu.
NOTE: After the HDD has been formatted, execute the Toshiba MS-DOS FDISK
command to partition the HDD. Next, execute the Toshiba MS-DOS FORMAT com-
mand. Refer to the Toshiba MS-DOS manual for more information about using these
commands.
T1960CS/T1960CT
Press [Cylinder number (dddd)] ?
Press [Head number (dd)] ?
Press [Cylinder number (dddd)] ?
Press [Head number (dd)] ?
3-41