Toshiba T1960CT Maintenance Manual page 38

Procedure 3 Format Check
The T1960CS/T1960CT's HDD is formatted using the low level format program and the MS-
DOS FORMAT program. To format the HDD, start with Check 1 below and perform the
other steps as required.
Check 1 Using the Toshiba MS-DOS system disk, partition the hard disk using the FDISK
command. Format the hard disk using FORMAT C:/S/U to transfer the system
program to the HDD. If the following message appears on the display, the HDD
is formatted.
Format complete
If any other message appears on the display, refer to the Toshiba MS-DOS
Manual for more information and perform Check 2.
Check 2 Using the T1960CS/T1960CT Diagnostic Disk, format the HDD with the low
level format option. Refer to Chapter 3, Tests and Diagnostics for more informa-
tion about the diagnostic program.
If the following message appears on the display, the HDD low level format is
complete. Partition and format the HDD using the MS-DOS FORMAT com-
mand.
Format complete
If you cannot format the HDD using the Test and Diagnostic program, go to
Procedure 4.
T1960CS/T1960CT
2-21