Toshiba T1960CT Maintenance Manual page 124

Installing the Display Assembly
To install the T1960CS/T1960CT's display assembly, follow the steps below and refer to
Figures 4-14 and 4-16.
1. Place the display assembly on the computer aligning the brackets with the screw
holes on the middle-frame assembly. Be sure to route the clear plastic insulator
between the display assembly and the bottom chassis (Figure 4-16.)
2. Replace the two M2.5x8 silver screws on the display hinges to secure the display
assembly (Figure 4-16).
CAUTION: If you replace a cable with a new one, be sure to bend and route it
as indicated in Figures 4-14 through 4-16 so that it fits snugly and will not be
pinched by the top cover or other components.
3. Connect the display sensor switch cable to PJ6 on the system board (Figure 4-
16) .
4. Connect the two display cables to PJ8 and PJ9 on the system board (Figure 4-
16).
5. Secure the M2.5x6 silver screw on the back of the computer (Figure 4-16).
6. Set the system board cover in place and secure the display ground cable with an
M2.5x8 silver screw (Figure 4-15).
7. Secure the system board cover with three M2.5x8 silver screws and two
M2.5x10 screws (Figure 4-15).
8. Place the clear plastic insulator over the display cables and press the insulator so
that it adheres to the system board cover (Figure 4-15).
9. Set the display unit at a 90º angle to the base and insert the two hinge covers
under the left and right hinges (Figure 4-14).
10. Install the display mask, keyboard base plate, keyboard, top cover, optional
PCMCIA card, optional memory card, and battery pack as described in Sections
4.12, and 4.7 through 4.2.
4-20
T1960CS/T1960CT