Toshiba T1960CT Maintenance Manual page 92

(c) Remove the Diagnostics Disk from the FDD, insert the source disk, and
press any key. The following message will appear, indicating the pro-
gram has started.
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = XX
Copy start
(d) Remove the source disk from the FDD, insert a formatted work disk,
and press any key. The [[ track, head = XXX X ]] message will appear
and start copying to the target disk. When the amount of data is too
large to be copied in one operation, the message from Step (b) is dis-
played again. After the floppy disk has been copied, the following
message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(e) To copy another disk, type 1 and the message from Step (a) will be
displayed again. Entering 2 returns the test program to the DIAGNOS-
TICS MENU.
4. DUMP program
(a) When DUMP is selected, the following message appears:
DIAGNOSTICS-HARD DISK & FLOPPY DISK DUMP : VX.XX
Drive type select (1:FDD, 2:HDD) ?
(b) Select a format type number. The following message appears:
Select drive number
(c) Select a drive number. If C or D is selected, the display will go to Step
(e), otherwise the following message will be displayed:
Format type select (1:2DD, 2:2D, 3:2HD) ?
(d) Select a media type number and the following message will appear:
Insert source disk into drive A:
Press any key when ready.
T1960CS/T1960CT
= XXX
= X
[[ track,head =
(1:A, 2:B) ?
(1:C, 2:D) ?
XXX X ]]
3-49